Anti skid embossing equipment

Check the hydraulic oil before using the anti skid embossing equipment. When the hydraulic oil height is 2/3 of the base height, when the refueling time is insufficient, fine filtration should be carried out before fuel injection. It adds pure hydraulic oil to the next refueling hole 20. It is generally suitable for stations with two-thirds of the height lower according to the oil level benchmark

check the lubrication between the guide pillar shafts and add oil in time to maintain good lubrication

power, move the joystick to the vertical position to close the oil return port, press the button to start the motor, the oil enters the cylinder from the pump, and the piston drive rises. When the hot plate is closed, the pump continues to supply, and when the stop button is pressed, the oil pressure rises to the required value (14.5mpa). When the machine is in the state of stopping packaging (i.e. timing vulcanization), reach the curing time, move the plunger to lower the handle of the mold

hot plate temperature control: rotate the close button SA1 to start the heating plate. When the temperature reaches the preset value, the heating will automatically stop. When the temperature is lower than the set value, the tablet is automatically heated, and the temperature is always maintained at the set value

vulcanizer control operation: press the button to start the motor, etc. 2. The AC contactor is powered on, and the pump runs. When the hydraulic pressure reaches the set value, the AC contactor is disconnected, and the starting curing time is automatically recorded. When the pressure drops, the pump motor starts automatic charging, reaching s. When et solidifies, Xiang Qi beeps to inform that the solidification time is up. You can turn on the mode, press the buzzer stop button, move the manual valve, and the board drops, which may be the next cycle