820 angle tile press

820 angle galloping tile press adopts high-quality automatic control software to realize production information management. The automatic control system of the whole unit adopts a highly integrated network, which makes the performance of the automatic system good. It also has the advantages of operation, maintenance, mechanical debugging, easy die replacement and so on

the problems that should be paid attention to in the production of 820 angle slip pressing machine are:

1. Please start the motor to idle first and observe whether it is normal

2. Place the machine at the intersection of the two plates, adjust the height of the feet on both sides, and pay attention to whether the roller is in the position to be pressed

3. Under normal circumstances, the bending width of the pressing plate is between 11-15mm, otherwise the machine is easy to fall off

4. The intersection of the two plates can be closely fastened together and cannot be disengaged, otherwise the machine is easy to disengage

5. Start the machine, and the user follows the machine. If the front two plates are disengaged, stop the machine and flatten the plates before starting the machine

6. Because this machine is formed at one time, the resistance in the pressing process is large. In order to determine the service life of the motor, please shut down for 5 minutes every 30 minutes

7. Be careful not to damage the roller during use and handling. It is forbidden to strike the roller with a blunt instrument

8. When not in use for a long time, all parts shall be lubricated with engine oil and wrapped to prevent rain leakage

820 main technical parameters of angle galloping tile press:

overall dimension of equipment installation: 1050m × 1400m × 13500m

total weight of equipment: about 9000kg

host power: 5.5kW

hydraulic shear power: 3kw

hydraulic station pressure: 10-12mpa

scale: 25m pitch: 205m

electric control system: the whole machine is controlled by industrial computer PLC

working speed: 8000m/min

roller material of tile press: 45 # hard chromium plating on steel surface

coverage width (m) 820

expanded width (m) 1000

plate thickness (m) 0.4-1.0

section inertia (cm4/m) 410