-
Single layer tile press series
-
Double layer tile press series
-
Three layer tile press series
-
Floor bearing plate equipment
-
Glazed tile equipment series
-
Jiaochi equipment series
-
C/z/u-shaped steel forming mac
-
Carriage plate forming machine
-
Anti skid embossing equipment
-
Aluminum magnesium manganese 4
-
Ridge tile forming machine ser
-
Light steel keel machine serie
-
Shearing machine bending machi
-
Rock wool foam integrated sand
-
Rolling shutter door equipment
-
Discharge rack series of hydra
-
Export equipment series
-
Kaiping machine series
-
pipe benders
-
Customize cold bending equipme
840 veneer tile press
840 veneer tile press adopts automatic control software to realize production information management. It has the characteristics of simple operation, easy maintenance and automatic operation. The color coated board produced by processing has novel appearance and even wave crest
840 it is strictly forbidden to stop the task beyond the small closing height, that is, the small interval between the bottom surface of the upper sliding box and each surface of the task is 290 mm. It is required to add the height of the upper and lower molds after mold closing, and the thickness of the upper and lower base plates plus the thickness of the tile blank, which is not allowed to exceed 290 mm. When manufacturing molds, the design should be stopped according to this requirement to avoid machine tool accidents. Different models are customized according to customer requirements
commissioning before application of 840 veneer tile press:
first measure the height of the four corners of the front and rear queues of the color steel tile press equipment from the gantry to the upper end of the shaft, then from the row to the next row, find a line to straighten, check whether the lower shaft is in a straight line, and adjust the left and right sides of the lower shaft to be horizontal. Align the color steel tile equipment row with the rear row, then fasten the lock nuts on both sides, pull a straight line in front of and behind the center of the middle wheel, and adjust the gap between the upper and lower shafts, and then adjust the machine along the straight line. If the plate runs to the right, pad the left corner (feeding rack), or fall to the right bottom level (the axis deviates and falls to the bottom level of the axis, and the upper axis falls with the bottom axis). The structure of the color steel tile press is reasonable and easy to operate, and the plate is formed by feeding, molding, dripping, heating, trimming, slotting and cutting. It adopts meticulous low-speed metering pump, variable-frequency speed regulation, computer control, and accurate metering
840 technical parameters of veneer tile press:
length * width * height: 6800mm*1300mm*1200mm
machine weight: about 2.6t
materials for large frame: 250h steel
thickness of medium plate: 12mm
forming shaft: diameter 68mm45 35; quenching and tempering
forming wheel: material 45 # forging and hard chromium plating
transmission mode: 6-point sprocket Chain
power: 4kw main machine with cycloid reducer
number of forming rows: 13 rows
forming speed: 8-10m/min
pressing thickness: 0.2-0.7mm
pressing width: 1000mm
pump station motor: 3kw